![]() The platform shall not deflect more than 1/60 of the span when loaded.Platforms shall be entirely planked and decked with space not more than one inch wide between the platforms and uprights.Platforms shall be constructed as follows: Damaged or deteriorated equipment shall not be used.Īll scaffolds and their components must support without failure its own weight and at least four times the maximum intended load applied or transmitted to the scaffold. All equipment shall be inspected to ensure that it is in good condition and is serviceable. Stationary scaffolds over 125 feet in height and rolling scaffolds over 60 feet in height shall be designed by a professional engineer. 452 “Additional Requirements Applicable to Specific Types of Scaffolds”. 451 “General Requirements for Scaffolds” and. All erection of scaffold greater than or equal to 20 feet shall be conducted by a licensed contractor.Ī qualified person must design all scaffolding in accordance with OSHA. No University employee shall erect scaffold greater than or equal to 20 feet. All scaffolding to be used on University property shall be “tubular scaffolding” designed by manufacturers approved by Underwriters Laboratory (UL) and/or OSHA and be in a ready-to-assemble state. No University employee shall design scaffolding. Designing components in accordance with design specifications.īack to top General Requirements for Scaffolds.Making swaged attachments and spliced eyes on wire suspension ropes and.Designing platforms on two-point adjustable suspension types that are less than 36 inches wide to prevent instability.Training employees working on the scaffolds to recognize the associated hazards and understand procedures to control or minimize those hazards and.Qualified persons shall be responsible for: For erectors and dismantlers, determining the feasibility and safety of providing fall protection and access.For suspension scaffolds evaluating direct connections to support the load to be imposed and.Inspecting ropes on suspended scaffolds prior to each work shift and after every occurrence which could affect the structural integrity, and to authorize prompt corrective actions.Inspecting scaffolds and scaffold components for visible defects before each work shift, and after any occurrence which could affect the structural integrity, and to authorize prompt corrective action.Training employees involved in erecting, disassembling, moving, operating, repairing, maintaining, or inspecting scaffolding to recognize associated work hazards. ![]() Determining if it is safe for employees to work from a scaffold during storms or high winds, and ensure that a personal fall arrest system is in place.Directing employees who erect, dismantle, move or alter scaffolding.The competent person shall be trained in accordance with the Occupational Safety and Health Administration (OSHA) and responsible for: Ensuring all inspection and maintenance practices for scaffolds are conducted by a competent person in accordance with this policy and procedure.Įmployees affected by this policy are responsible for complying with the practices within the Scaffold Safety policy.Designating a qualified person to design and supervise during the erection, use and disassembling of scaffolding and.Ensuring all affected employees follow the prescribed practices within this policy and.Ensuring all affected employees are trained in accordance with this policy.ĭepartments affected by this policy are responsible for:.Reporting any questionable conditions that are discovered to the responsible department.Reviewing this policy to ensure compliance with current regulations.No University employee shall design any scaffolding.Įnvironmental Health and Safety is responsible for: All scaffolds used in construction, renovation, repair (including painting and decorating), and demolition shall be erected, dismantled and maintained in accordance with this policy and procedure. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |